www.elitescreens.eu
Manual SRMPro
QUICK USER’S GUIDE
Screen Installation
A. Flush Wall Installation
1. Measure the distance of the keyholes on the end caps and mark the location of where
the screen is to be installed for the pre-drilled hole.
2. After marking the area and drilling the hole, insert the proper screw into the drilled hole
and leave about 1/8” of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of screen’s left and right end caps.
Note: Do not remove the end caps to mount the screen to the wall.
Removing the end caps will release the tension of the internal spring mechanism.
(additional
hardware
required)
Optional
installation using
chains to hang the
screen from the ceiling.
1. You can also hang the screen on a ceiling by using a
chain (not included) and hang it by the two D-ring loops
located on the left and right side end caps.
Wall Mounting Screws Tip: For drywall installations, drywall
anchors and screws can be utilized to hang the screen from the
keyholes of the end caps. Please consult with a hardware store
for for your specific wall or ceiling installation.
Screen Operation
1. Pull the screen down from the lanyard or from the
handle only in a 90-degree angle. The screen is designed to
stop at any location. To achieve this, make sure to pull
straight down and allowing the screen to come up to lock
into place. Do not attempt to pull the screen down by the
surface or touch the screen, as it will damage the screen
and void the warranty.
2. To retract the screen, simply pull the screen down
more than 2 inches and retract the screen back releasing it
up gently. The screen is equipped with a SLOW
RETRACT MECHANISM which allows the screen to
slowly retract without the need to hold on to the handle or
lanyard.
Simply release the handle and the screen will retract by itself into the housing.
Attention: If the screen does not unlock, carefully pull the screen straight down with a little force. Always
pull the screen down at a 90 degree angle.
Keyhole located on
back of end cap
To Next Page
Loading...
Need help?
General
