Manual SRM Pro
QUICK USER’S GUIDE
121914-MSRM
Screen Installation
A. Flush Wall Installation
1. Measure the distance of the keyholes on the end caps and mark the location of where
the screen is to be installed for the pre-drilled hole.
2. After marking the area and drilling the hole, insert the proper screw into the drilled
hole and leave about 1/8” of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of screen’s left and right end caps.
Note: Do not remove the end caps to mount the screen to the wall.
Removing the end caps will release the tension of the internal spring mechanism.
B. Ceiling Installation(additional hardware required)
Optional installation using chains to hang the screen from the
ceiling.
1. You can also hang the screen on a ceiling by using a
chain (not included) and hang it by the two D-ring loops
located on the left and right side end caps.
Wall Mounting Screws Tip: For drywall installations, drywall
anchors and screws can be utilized to hang the screen from the
keyholes of the end caps. Please consult with a hardware store for
proper screws for your specific wall or ceiling installation.
Screen Operation
1. Pull the screen down from the lanyard or from the handle
only in a 90-degree angle. The screen is designed to stop at
any location. To achieve this, make sure to pull straight
down and allowing the screen to come up to lock into place.
Do not attempt to pull the screen down by the surface or
touch the screen, as it will damage the screen and void
the warranty.
2. To retract the screen, simply pull the screen down more
than 2 inches and retract the screen back releasing it up
gently. The screen is equipped with a SLOW RETRACT
MECHANISM which allows the screen to slowly retract
without the need to hold on to the handle or lanyard.
Simply release the handle and the screen will retract by itself into the housing.
Attention: If the screen does not unlock, carefully pull the screen straight down with a little force. Always
pull the screen down at a 90 degree angle.
For more information or for tech support, please visit www.elitescreens.com
To Next Page
Need help?
General
