Elite Screens ezFrame 2 Series User Manual

Rev. V10312023DT (DS0280 / DZUG0265) 1 www.elitescreens.com
ezFrame 2 &
Sable Frame 2 Series
Fixed Frame Projection Screen
User’s Guide – V type
________________________________________________________________________________________________________________________________
Thank you for choosing an Elite Screens fixed frame projection screen! Please read through this user guide before
utilizing the screen. Correct usage and maintenance will ensure a long product life.
Care & Use Instructions
Dust, dirt and scratches on the projection surface will affect the picture quality, please take note of the points
below to prevent that from occurring:
1. Do not touch the projection surface with your hands
2. Do not write or draw on the projection surface
3. Do not use fingers or sharp objects to point on the projection surface; this will damage the screen
material.
4. Use a soft-damp cloth to clean the projection surface; do not use chemical cleaning agents or alcohol.
5. Use clean water when dampening the cleaning cloth and do not rub against the material to clean it.
Hardware and Parts List
Note: Please make sure all parts are included in your package before proceeding to assemble your fixed frame
projection screen.
a: Frame parts x 6
b: Elbow Joints x 4
c: Center Joints x 2
d: M5*6 screw x 24
e: Fix Plates x 50~200
f: M4*32 Wall Screw x 8
g: Ø 13*40 Anchors x 8
h: Wall Brackets x 4
i: Center Support Bar x 1 ~ 2
j: Gloves x 2
k: Protection Sheet x 1
l: Screen Material x 1
m: Ø 12*Ø 4*1 Washers x 8
n: Rubber Hammer x 1
o: Screwdriver x 1

Elite Screens ezFrame 2 Series Specifications

General

Screen Type	Fixed Frame
Gain	1.1
Frame Material	Aluminum
Frame Surface	Black Velvet
Aspect Ratio	16:9, 2.35:1, 4:3
Frame Color	Black
Installation	Wall-mounted
Viewing Angle	160 degrees

Summary

Care & Use Instructions

Hardware and Parts List

Frame Assembly

Assemble Horizontal Frames

Assemble the two 1/2 size horizontal frames using center joints and M5*6 screws.

Attach Vertical Frames

Insert elbow joints into short vertical frames and attach long frames.

Join Frame Parts

Join all four frame parts together, pushing simultaneously on the ends of the long frames.

Attaching Screen Material

Prepare for Material Attachment

Lay screen material and frame face down on protection sheet, wear gloves, and unroll material.

Secure Corners with Fix Plates

Stretch material to corner, insert edge into groove, and snap fix plates to secure corners.

Install Center Fix Plates

Place fix plates in the center of each side of the frame.

Fasten Remaining Fix Plates

Fasten fix plates on the center of each frame side and in remaining marked locations.

Center Support Bar Installation

Insert and Align Support Bar

Insert center support bar into frame groove, align ends at an angle, and remove buckle.

Complete Bar Installation

Slide the top end of the bar into the top center point of the frame.

Wall Installation

Determine Mounting Location and Dimensions

Locate installation spot using stud finder and reference table for bracket distances.

Prepare and Install Wall Brackets

Drill holes, insert anchors, and screw wall brackets into the wall.

Mount Screen Frame to Brackets

Position frame onto top brackets, pull down to secure, then push lower frame into lower bracket.

Safety and Maintenance Precautions

Installation Safety Guidelines

Ensure clear space, use proper anchors, and consult specialists for wall mounting advice.

Screen Handling and Cleaning

Handle frame parts with care, cover screen when not in use, and clean with damp cloth.

General Handling Warnings

Avoid touching screen with fingers/tools, keep spare parts from children, and do not use chemicals.