Elite Screens ezFrame 2 Series - Wall Installation; Determine Mounting Location and Dimensions; Prepare and Install Wall Brackets; Mount Screen Frame to Brackets

Rev. V10312023DT (DS0280 / DZUG0265) 6 www.elitescreens.com
Installation
1. Locate your desired installation location with a stud finder (recommended) and mark the drill-hole area of where
the screen is to be installed. Reference the table below for:
2. Drill a hole with the proper bit size according to the Ø13*40 Anchors (g) and M4*32 Wall Screw (f)
included.
3. Line up the Wall brackets (h) with the drilled holes on the installation location and screw them in using a
screwdriver.
4. Position the fixed frame screen onto the top wall brackets as shown as below info and pull down at the center
of the bottom frame to secure the installation.
5. The design of the wall brackets allows the frame to slide over them through its sides. This is an important
feature of the installation design as it allows your screen to be properly centered.
6. Using both hands finish the installation by pushing the lower portion of the fixed frame screen into the lower
bracket as shown in below info.
Unit: mm (inch)
100”
110”
120”
135”
150”
165”
L = Wall bracket distance
1500
(59.1”)
1500
(59.1”)
1500
(59.1”)
2000
(78.7”)
2000
(78.7”)
2500
(98.4”)
H = Top/Bottom Wall Bracket
Height distance
1284
(50.6”)
1414
(55.7”)
1534
(60.4”)
1724
(67.9”)
1914
(75.4”)
2103
(82.8”)
Top wall bracket (h)
Wall
Pull
Pull
M4*32 Wall screw (f)
Wall anchor (g)
Bracket hole distance
= 1.57” (40mm)