___________________________________
www.elitescreens.eu
shop@elitescreens.eu
ELITE SCREENS
How to adding the spring force for Manual SRM Pro screen
1. Put the screen on the clean table, pull the material down a little and make it is in the
locked state. As the picture shown below.
2. Remove the screws on the left end cap with a screwdriver, and remove the left end cap,
and move the axis out a little. As the picture shown below.
3. Install the left end cap , rotating it in clockwise direction, release the locking, use one
hand to hold the axis, remove the end cap to release the spring force.（This step need
to be operated twice, to prevent the original spring force didn’t remove completely
To Next Page
Loading...
