Leg Attachment for 100”/ 120” Models
1. Carefully take the left and right folding legs (B) out of the carrying bag (F) and place it on a flat surface. Unfold the
left and right legs leaving the front foot folded as shown below. Make sure the hinges click into place.
Warning: The additional support sections, located at the middle section of the legs, may unfold on its own. Please be sure to use
caution while removing/placing the legs from/to the bag
2. Once the legs are unfolded, lay the frame on the floor and position the legs over both sides of
the frame.
Use the knob screws (C) to attach the frame to the legs.
Warning: When attaching the legs, make sure to screw the top of the leg to the last hole of the frame to reach max height.
Attaching the legs lower to the frame and leaving an extra space on top may cause the screen to tip over when assembled.
3. After making sure the legs are secure to the frame, using two people, lift the screen up in a vertical position. While
the screen is in a vertical position, fold the front feet of the legs out.
4. The assembly is now complete, and the projection screen will be stable on a flat surface.
Leg Attachment for 135” – 200” Models
1. Starting from step 2 on the previous procedure, lay the frame on the floor and
position the legs over both sides of the frame. Use the knob screws (C) to attach the
frame to the legs.
Warning: When attaching the legs, make sure to screw the top of the leg to the last hole of
the frame to reach max height. Attaching the legs lower to the frame and leaving an extra
space on top may cause the screen to tip over when assembled.
To Next Page
Loading...
Need help?
General
