Need help?Do you have a question about the Elite SL-3000-UL SERIES and is the answer not in the manual?
General| Brand | Elite |
|---|---|
| Model | SL-3000-UL SERIES |
| Category | Gate Opener |
| Language | English |
Guidelines for installing gate operators based on UL standards.
Critical safety warnings and procedures to follow before operating the gate.
Defines gate operator classes (I-IV) and general gate terminology for proper classification.
Requirements for installers regarding the placement and securing of UL required warning signs.
Specific warnings about pedestrian access, control device placement, and gate operation safety.
Specifications for SL-3000-UL, SL-3000-UL-DM, and SL-3000-UL-1HP models.
Describes three common installation types: front, rear, and ceiling mount underground.
Details on connecting the drive chain for front and rear gate operator installations.
Guidance on selecting the correct movement direction for the gate operator.
Procedure for adjusting the gate's travel distance using the control board.
Instructions for adjusting the reversing sensor sensitivity and the timer settings.
Steps to configure two gate operators as master and slave with timers set to ON.
Setting up partial master/individual control and examples for double gate operations.
Details on connecting solenoid or magnetic locks using the J3 plug.
Explanation of the QCC circuit and its two operational modes (A and B).
Instructions for connecting a maglock using an optional board.
Connecting house alarm systems and proximity switches with the master/slave setup.
Guide for installing a three-push-button station (open, stop, close) with the option board.
Diagram showing connections for key switches, card readers, push buttons, and loop detectors.
How the exit loop system allows the gate to open automatically for exiting vehicles.
Details on standard, Option 1 (CP-17), and Option 2 (DC-1000U-SL) emergency release mechanisms.
Explanation of the audio alarm that sounds upon consecutive gate operational faults.
Guidance on installing edge sensors for optimal entrapment protection and safety.
Common issues like "Gate Will Not Close" or "Gate Will Not Open" and their potential causes.
Routine maintenance tasks including checking sensors, cleaning tracks, and cleaning the cover.
To Next Page
