Elkay EZH20 LZWSMD* User Manual (English)

To Next Page

98557C (Rev. C - 3/2011)

LZWSM8*, LZWSMD*, LZWSM8P*, LZWSMDP*, LZWSM8*-2, LZWSM8*-3, LZWSMD*-2, LZWSMD*-3, LZWSM8P*-2, LZWSM8P*-3, LZWSMDP*-2, LZWSMDP*-3

EZWSM8*, EZWSMD*, EZWSM8P*, EZWSMDP*, EZWSM8*-2, EZWSM8*-3, EZWSMD*-2, EZWSMD*-3, EZWSM8P*-2, EZWSM8P*-3, EZWSMDP*-2, EZWSMDP*-3

Installation/Care/Use Manual

EZH20 In Wall Bottle Filling Station

To assure you install this model easily and correctly,

PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE

INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH

PLUMBING, ELECTRICAL AND OTHER APPLICABLE CODES. After installation, leave

these instructions inside the fountain for future reference.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

IMPORTANT! INSTALLER PLEASE NOTE.

THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO

WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY

OCCUR AWAY FROM THE BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK

INTO A FOUNTAIN, CREATING AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN

INCREASE IN THE METAL CONTENT OF THE WATER. THIS CONDITION IS AVOIDABLE BY USING

THE PROPER MATERIALS AS INDICATED. ANY DRAIN FITTINGS PROVIDED BY THE INSTALLER

SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN FROM THE BUILDING

PLUMBING SYSTEM. WE SUGGEST THAT THE BOTTLE FILLER BE PROTECTED BY A GROUND

FAULT CIRCUIT INTERRUPTER (GFCI)

FIG. 2FIG. 1

Installer

NOTE: WATER FLOW

DIRECTION

BUILDING WATER

INLET

SERVICE STOP

(NOT FURNISHED)

1/4" O.D. TUBE

WATER INLET

TO COOLER

3/8" O.D. UNPLATED

COPPER TUBE CONNECT

COLD WATER SUPPLY

LZWSM8* LZWSMD* LZWSM8P* LZWSMDP*

EZWSM8* EZWSMD* EZWSM8P* EZWSMDP*

PAGE 1

Need help?

Do you have a question about the Elkay EZH20 LZWSMD* and is the answer not in the manual?

Elkay EZH20 LZWSMD* Specifications

General