What to do if the main breaker tripped on my Elmec EVduty EVCCS?
If the Elmec Accessories' main breaker tripped, verify the 'Circuit breaker value' in the EVCCS module configuration matches the circuit breaker's value. Also, ensure the 'Channel ID' in the EVC30 charging station configuration is not set to '0 = disabled'.
Why is the "Power" LED not lit on my Elmec EVduty EVCCS Accessories?
If the "Power" LED is not lit on your Elmec Accessories, it could be due to the EVCCS module not receiving enough power. First, check that the power outlet provides adequate voltage. If the outlet is fine, ensure the power supply unit has an output voltage of +5VDC.
Why is my Elmec EVduty EVCCS EVC30 charging station charging so slowly?
If the Elmec Accessories EVC30 charging station is charging vehicles very slowly (at approximately 6A), this is normal when the electrical panel’s power consumption is very close to the allowed limit. Another possible cause is loss or absence of communication between the EVCCS module and the EVC30 charging station. Check the local network to which the EVCCS module and the EVC30 charging station are connected.
What to do if the "Network communication" LED flashes green only twice on Elmec EVduty EVCCS Accessories?
If the "Network communication" LED flashes green only twice on your Elmec Accessories, it means the EVCCS module isn't properly connecting to at least one EVC30 charging station. You should check the 'Channel ID' in both the EVCCS module and the EVC30 charging station configurations, ensuring they are identical. Also, verify that both devices are on the same local network and that the network allows communication between them.
How to fix "Network communication" LED flashing green once on Elmec EVduty EVCCS Accessories?
If the "Network communication" LED flashes green only once on your Elmec Accessories, the EVCCS module might not be properly configured to connect to the local network. Check the parameters in the EVCCS module configuration. If connected via Ethernet, check the connections at each end of the cable and the router settings.
Measures total current for all electrical equipment powered by the main panel.
Measures current consumed by equivalent electrical equipment.
Steps to configure the EVCCS module, including password creation and initial network setup.
Configures Channel ID, Current Sensing Type, and Circuit Breaker Value for the EVCCS module.
Configures WiFi SSID, password, IP address, gateway, subnet mask, and DNS server for the EVCCS module.
Steps to configure the EVC30 charging station for communication with the EVCCS module.
Configures WiFi network, password, access mode, and load shedding channel for the EVC30 charging station.
Verifies proper communication establishment between the EVCCS module and the EVC30 charging station.
Details the meaning of Power, Network communication, and Error LED states on the EVCCS module.
Lists common problems, their causes, and provides solutions for the EVCCS module and charging station.
General| Brand | Elmec |
|---|---|
| Model | EVduty EVCCS |
| Category | Accessories |
| Language | English |
To Next Page