What to do if ELMECO BB2 machine does not make cold and the “slush” led, “cold drink” led and “1” led blink?
If your ELMECO Commercial Food Equipment is in protection mode due to increasing internal temperatures, make sure the machine is positioned correctly as shown in fig. 5 in appendix-58, and carry out the condenser cleaning procedure described on page 21 to avoid repeating this situation.
What to do if ELMECO BB2 tank does not make cold and the cooling light is off?
Here's what to do: * Empty the tank. * Switch off the slush machine by the main switch. * Pour into the tank a product with a temperature higher than 15°C. * Wait at least 5 minutes and switch on the machine again. * Select on the electronic board “slush” mode. The electronics calibration is automatic, and the status will be displayed on the electronic board by the blink of led “3”. The blink will stop when the calibration is finished.
Why do I hear a creaking during the augers rotation of ELMECO Commercial Food Equipment?
The creaking you hear during auger rotation in your ELMECO Commercial Food Equipment likely comes from the vertical and horizontal auger gears. You can reduce this noise by applying some Vaseline to the plastic gears.
What does it mean when the “3” led blinks on ELMECO Commercial Food Equipment in “slush” mode?
When the electronic board starts the calibration procedure after you turn on the ELMECO Commercial Food Equipment in “slush” mode, and the product temperature is higher than 5°C, the “3” LED will blink for about 2 minutes during the calibration.
What to do if leds “1” and “slush” mode blink and the augers are rotating in ELMECO BB2 Commercial Food Equipment?
If the “1” and “slush” mode LEDs are blinking and the augers are rotating on your ELMECO Commercial Food Equipment, disconnect the power electric cable. Then, check the connection between the electronic board and the brushless gearmotor, looking for any oxide on the two connectors.
What to do if the led 2 blinks on ELMECO BB2 Commercial Food Equipment?
Replace the cable that connects the thermostat probe to the electronic board, making sure there is no oxide on it. If there is, clean the contacts. If the problem persists, replace the thermostat probe.
Instructions for cleaning the machine, including the tank and components.
Explanation of machine controls, indicators, and operating modes.
Troubleshooting guide based on LED indicators and error codes.
Step-by-step guide for preparing slush and cold drinks.
Optional timer function for defrosting or switching between modes.
Diagrams and list of key electrical components.
Diagram illustrating the refrigeration system components and layout.
Visual representation of machine parts with identification numbers.
Explanation of warning symbols and general safety precautions.
Rules and restrictions for safe appliance operation and usage.
Critical safety rules for machine usage and maintenance.
Guidelines for disposing of old machines and environmental impact.
Statement of compliance with relevant EEC directives and standards.
Details on warranty terms, coverage, and exclusions.
Instructions for registering the product warranty.
Specifics of the global warranty, including service coverage and exclusions.
General| Brand | ELMECO |
|---|---|
| Model | BB2 |
| Category | Commercial Food Equipment |
| Language | English |
To Next Page
