What to do if ELMECO Commercial Food Equipment machine does not make cold and the “slush” led, “cold drink” led and “1” led blink?
If your ELMECO Commercial Food Equipment is in protection mode due to increasing internal temperatures, make sure the machine is positioned correctly as shown in fig. 5 in appendix-58, and carry out the condenser cleaning procedure described on page 21 to avoid repeating this situation.
What to do if ELMECO BB1 tank does not make cold and the cooling light is off?
Here's what to do: * Empty the tank. * Switch off the slush machine by the main switch. * Pour into the tank a product with a temperature higher than 15°C. * Wait at least 5 minutes and switch on the machine again. * Select on the electronic board “slush” mode. The electronics calibration is automatic, and the status will be displayed on the electronic board by the blink of led “3”. The blink will stop when the calibration is finished.
Why do I hear a creaking during the augers rotation of ELMECO BB1?
The creaking you hear during auger rotation in your ELMECO Commercial Food Equipment likely comes from the vertical and horizontal auger gears. You can reduce this noise by applying some Vaseline to the plastic gears.
What does it mean when the “3” led blinks on ELMECO BB1 in “slush” mode?
When the electronic board starts the calibration procedure after you turn on the ELMECO Commercial Food Equipment in “slush” mode, and the product temperature is higher than 5°C, the “3” LED will blink for about 2 minutes during the calibration.
What to do if leds “1” and “slush” mode blink and the augers are rotating in ELMECO BB1 Commercial Food Equipment?
If the “1” and “slush” mode LEDs are blinking and the augers are rotating on your ELMECO Commercial Food Equipment, disconnect the power electric cable. Then, check the connection between the electronic board and the brushless gearmotor, looking for any oxide on the two connectors.
What to do if the led 2 blinks on ELMECO BB1?
Replace the cable that connects the thermostat probe to the electronic board, making sure there is no oxide on it. If there is, clean the contacts. If the problem persists, replace the thermostat probe.
Rules and restrictions for the safe operation and use of the appliance.
Essential checks to perform before proceeding with the machine installation.
Critical safety warnings related to the installation process.
Step-by-step guidance for installing the machine correctly.
Essential guidelines and precautions for cleaning the appliance.
Step-by-step procedure for disassembling and cleaning the tank.
Steps to clean the condenser for optimal performance.
Essential safety rules for operating the machine.
Key for understanding electrical system diagram symbols and wire colors.
Details on manufacturer's responsibility and compliance with directives.
Conditions and parts not covered by the product warranty.
General| Brand | ELMECO |
|---|---|
| Model | BB1 |
| Category | Commercial Food Equipment |
| Language | English |
To Next Page
