(where Y is a variable number
between 2 and 5 for Cold Drink Mode,
which indicates the temperature in °C
at which the product must be
prepared).
Using and you can increase
or decrease the temperature of the
product. The recommended
temperature is 4°C.
If you press the button, the
screen will display as follows:
(
a
°C
).
°C.
SLUSH
* X
(where X is a variable number
between 1 and 9 and indicates the
density of the slush). If you use the
and buttons it is possible to
increase or decrease the slush density
value.
(
a
.
Warning: If, when the electronic
board is in Slush Mode, the product
temperature is greater than 5°C, the
following screen will be displayed:
°C
:
Auto / Setting / Wait
* X
This screen indicates that the
calibration process is taking place. The
calibration process will take one
minute to complete.
.
If you press the button (Cooling
off- cold drink- slush) you can switch
the machine functioning modes
alternatively. Each time you press the
button, the different screens of cold
drink slush and cooling off alternate.
In this latter position only the augers
rotate and no other action is taken.
.
If you press the auger rotation key
, the display will appear as
follows:
::
StandBy
Press
By holding the button for
one second you will enter the
selection menu.
Please note that unless you give any
further instruction to the electronic
board in more 10 seconds time, the
display will automatically go back to
the initial screen.
.
.
This screen allows you to turn ON or
OFF the light in the lid, by pressing the
and buttons of the electronic
board.
.
LAMP
OFF / ON
In this screen you can activate or
deactivate the bypass function by
pressing the increase and
decrease keys.
..
ByPass
OFF / ON
This screen allows you to turn ON or
OFF the Low Level control function
to no.1, when the level probe is not
covered with product for more than 20
minutes); you can do that by pressing
the increase key or the decrease
key.
.
LowLevel
OFF / ON
If you add some product (liquid that
touches the level probe), the function
will be deactivated and the slush
preparation will reach the density value
that was previously set on the
electronic board. When this function is
active, you will see the following
display:
:
To Next Page
Loading...
Need help?
General
