During maintenance and cleaning, or
in case of bad functioning, disconnect
the machine from the power plug (by
pulling the plug and not the cable) (pic.
2 and 3 pag.3).
Only specialized and authorized staff
can repair the machine. Not perfect
repairing can be dangerous for the
user. Contact Elmeco for information
concerning the closer authorized
assistance centre.
For correct operation use the machine
at maximum temperature of 43°C and
minimum 27°C.
For safe operation the maximum tilt of
the appliance is 1,5 degree towards
the front side (outlet).
The appliance is not suitable for
installation in an area where a water
jet could be used.
The appliance is only to be installed in
locations where its use and
maintenance is restricted to trained
personnel.
pag 3).
Elmeco
.
°C
°C.
).
a
.
.
Important security
rules
• Do not touch the machine when
you have wet hands and/or feet.
• Do not use the machine with bare
feet.
• Do not allow children or
incompetent people to use the
machine.
• Do not leave the machine
exposed to atmospheric agents.
• Do not pull the power supply cable
to disconnect the machine from
the electric power.
• Do not remove the panels before
disconnecting the machine from
the electric power.
• This appliance is intended to be
used in household and similar
applications such as
staff kitchen areas in shops,
offices and other working
environments;
farm houses and by clients in
hotels, motels and other
residential type environments;
bed and breakfast type
environments;
catering and similar non-retail
applications.
• "
.
• "
.
• "
.
• "
.
• "
.
• "
.
•
:
.
Technical assistance
The repairing of the machine must be
carried out by an authorized service
centre, using only original spare parts.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard
.
a
Illuminating lamps
replacing
In case of replacing of the lamp follow
the procedure:
1. Switch off the machine;
2. Remove the top light complete
cover from the transparent tank;
3. Separate the top light from the
transparent lamp glass;
4. Change the old illuminating lamp
with new one (12Vac -10watt);
5. Assembly the top light with the
transparent lamp glass;
6. Reposition the top light complete
cover on the transparent tank.
1
2
3
4
Vac -10
5
6
To Next Page
Loading...
Need help?
General
