Need help?Do you have a question about the Elmo FILMATIC 16-A and is the answer not in the manual?
General| Super/Single 8mm | no |
|---|---|
| 16mm | yes |
| Threading | automatic |
| Sound Speed | 24 fps |
| Projection Speed | 18, 24 fps |
| Film Capacity | 600m |
Details power requirements and the type of projection lamp used.
Lists standard lens, available lenses, and projection speeds.
Describes automatic film threading, loop restoration, and sound capabilities.
Covers amplifier circuit, tone controls, and speaker specifications.
Explains how to engage slow motion and still projection modes.
Details reverse film movement and remote control operation.
Instructions on how to rewind the film after projection is finished.
Guide for cleaning the projector's film gate to prevent film damage.
Instructions on gently cleaning the front and rear surfaces of the projection lens.
Step-by-step guide for safely replacing the projector's main lamp.
How to adjust lamp position to optimize image brightness and uniformity.
Details on how to replace the exciter lamp for sound reproduction.
Guidance on replacing power and amplifier fuses, including fuse ratings.
Instructions for maintaining the oil level in the film feeding mechanism.
Recommendations for lubricating the projector's bearings.
Identifies common causes for film not threading and provides solutions.
Addresses issues like the motor not running or the projection lamp not lighting.
Covers problems with sound reproduction, self-threading, and loop restorers.
Details special lenses and a rear projection device for enhanced viewing.
Information on available sizes of translucent screens for rear projection.
Describes specialized lenses for varying projection distances and room sizes.
To Next Page
