16
Attaching the Dual Feed Foot AD
z Attach the dual feed holder to the presser bar.
q Dual feed holder
x Tighten the setscrew with your fingers.
Push the dual feed link to engage it with upper feed
drive.
w Dual feed link
e Upper feed drive
c Lower the presser foot lifter. Lower the needle to the
lowest position by turning the handwheel.
v Tighten the setscrew securely with the screwdriver.
z x
c
v
Attaching the Darning Foot PD-H
Attach the darning foot PD-H to the presser bar by
putting the pin on the needle clamp screw.
q Pin
w Needle clamp screw
Tighten the setscrew firmly with the screwdriver.
Attaching the Professional Grade Foot HP
Attach the professional grade foot HP to the presser bar.
Tighten the setscrew firmly with the screwdriver.
w
q
e
w
q
w
To Next Page