Type no.: 350HB002 Version: 1.3 Date: 13.04.2016 1-2
1.3 Abbreviations and symbols
1.4 Applicable standards
eloProg complies with the following European Directives:
2006/42/EC “Machinery Directive”
2004/108/EC “Electromagnetic Compatibility Directive”
2006/95/EC “Low-voltage Directive”
The following standards are complied with:
Tab. 1-1 Applicable standards
350EPS = eloProg memory stick for basic module 485EPB (accessory)
350EPT = eloProg T-distributor
350EPKS = eloProg configuration software
OSSD = Output Signal Switching Device: solid state safety output (safety output)
DC = Diagnostic Coverage: level of diagnostic coverage
MTTF
d
= Mean Time to Dangerous Failure
PL = Performance Level
PFH
d
= Probability of a dangerous failure per Hour
SIL = Safety Integrity Level
SILCL = Safety Integrity Level Claim Limit
SW = Software
CEI EN 61131-2
(2007)
Programmable controllers, part 2:
Equipment characteristics and tests
ISO 13489-1
(2008)
Safety of machinery:
Safety related parts of control systems. General principles for design
EN 61496-1
(2013)
Safety of machinery: Electro-sensitive protective systems, Part 1:
General requirements and tests
IEC 61508-1
(2010)
Functional safety of electrical/electronic/programmable electronic safety-related systems:
General requirements
IEC 61508-2
(2010)
Functional safety of electrical/electronic/programmable electronic safety-related systems:
Requirements for electrical/electronic/programmable electronic safety-related systems
IEC 61508-3
(2010)
Functional safety of electrical/electronic/programmable electronic safety-related systems:
Software requirements.
IEC 61784-3
(2008)
Digital data communication for measurement and control: Functional safety field buses
IEC 62061
(2013)
Safety of machinery: Functional safety of safety-related electrical, electronic and programmable electronic
control systems
To Next Page