Elprotronic MSP430 - Page 24

C:\Program Files\Elprotronic\MSP430\USB FlashPro430\API-DLL-Demo\VBnet
VB6 version
C:\Program Files\Elprotronic\MSP430\USB FlashPro430\API-DLL-Demo\VB6
Labview (ver 7.1)
C:\Program Files\Elprotronic\MSP430\USB FlashPro430\LabView
when the FlashPro430 package is used, or in directory
C:\Program Files\Elprotronic\MSP430\FET-Pro430\API-DLL-Demo\Cpp\Exe
VBnet version
C:\Program Files\Elprotronic\MSP430\FET-FlashPro430\API-DLL-Demo\VBnet
VB6 version
C:\Program Files\Elprotronic\MSP430\FET-FlashPro430\API-DLL-Demo\VB6
Labview (ver 7.1)
C:\Program Files\Elprotronic\MSP430\FET-FlashPro430\LabView
when the FET-Pro430 package is used.
It is recommended to also copy the demo software
FlashPro-Multi-FPA-Demo.exe
taken from the Elprotronic’s directory (default location)
C:\Program Files\Elprotronic\MSP430\USB FlashPro430\API-DLL-Demo\Cpp\Exe
To make a run the demo program, then the following files should be located in the same directory
where the executable program in located. Assume that the demo program
FlashPro-Multi-FPA-Demo.exe
is used, then also the following files should be located in the same directory
MSP430FPA.dll - Multi-FPA selection/distribution DLL
MSP430FPA1.dll - required if the USB-MSP430-FPA adapter is used
MSPFET430UIF1.dll - required if the TI’s MSP-FET430UIF is used
config.ini - (optional) default configuration file for the FPAs
The FlashPro-Multi-FPA-Demo.exe program contains GUI (Figure 2.3) that allows to activate
one or more Flash Programming Adapters (FPA), TI’s MSP-FET430UIF adapter or mixed like in
an example below - USB-MSP430-FPA and MSP-FET430UIF adapters . When one adapter is used
then the button Open Instances And FPA (“*# *”) should be pressed. The first detected FPA
24