Elprotronic MSP430 - Page 58

ReadSegmA - Read from the Info Segment A
[ CFG_READINFOB 12 ]
ReadSegmB - Read from the Info Segment B
[ CFG_READINFOC 22 ]
ReadSegmC - Read from the Info Segment B
[ CFG_READINFOC 23 ]
ReadSegmD - Read from the Info Segment B
if FlashReadModeIndex = READ_DEF_MEM_INDEX
[ CFG_READSTARTADDR 13 ]
ReadStartAddr 0x1100 to 0x1FFFE ;see above
[ CFG_READSTOPADDR 14 ]
ReadStopAddr 0x1101 to 0x1FFFF ;see above
[ CFG_VERIFYMODE 15 ]
VerifyModeIndex - Program Verification method
VERIFY_NONE_INDEX 0 - no verification
VERIFY_STD_INDEX 1 - standard verification (read and verify)
VERIFY_FAST_INDEX 2 - fast verification (calculate CS and verify)
[ CFG_BLOWFUSE 16 ]
BlowFuseEn - Blow the security fuse - only using JTAG/SBW interface
0 - disable
1 - enable when called from F_Blow_Fuse()
3 - enable when called from F_Blow_Fuse() or F_Autoprogram(..)
[ CFG_APPLSTARTEN 17 ]
ApplicationStartEn - reset and start the microcontroller’s
application software when flash is successfully
programmed
APPLICATION_KEEP_RESET 0 - Hardware Reset Line permanent LOW
APPLICATION_TOGGLE_RESET 1 - Hardware Reset (Pulse Low)
APPLICATION_TOGGLE_VCC 2 - Toggle VCC Reset
APPLICATION_JTAG_RESET 3 - JTAG software reset
[ CFG_BEEPEN 18 ]
BeepEnable - beep on the end of flash programming
0 - disable
1 - enable
[ CFG_JTAGSPEEDINDEX 24 ]
JtagSpeedIndex - valid for the USB model only
JTAG_SPEED_1MB_INDEX 0 //JTAG 4Mb/s, Spy-Bi-Wire->FAST
JTAG_SPEED_4MB_INDEX 1 //JTAG 1Mb/s, Spy-Bi-Wire->FAST
58