Elprotronic MSP430 - Page 59

JTAG_SPEED_400K_INDEX 2 //JTAG 400kb/s, Spy-Bi-Wire->SLOW
[ CFG_VCCINDEX 25 ]
VccIndex - valid for the USB-MSP430-FPA version 2.x and higher
VCC_2V2_INDEX 0
VCC_2V4_INDEX 1
VCC_2V6_INDEX 2
VCC_2V8_INDEX 3
VCC_3V0_INDEX 4
VCC_3V2_INDEX 5
VCC_3V4_INDEX 6
VCC_3V6_INDEX 7
[ CFG_CUSTOMRESETPULSETIME 26 ]
CustomResetPulseTime value 1 to 1000 step 1 in miliseconds
valid only when the ResetTimeIndex = RESET_CUSTOM_INDEX
[ CFG_CUSTOMRESETIDLETIME 27 ]
CustomResetIdleTime value 1 to 2000 step 1 in miliseconds
valid only when the ResetTimeIndex = RESET_CUSTOM_INDEX
[ CFG_RSTVCCTOGGLETIME 28 ]
RstVccToggleTime value 50 to 5000 step 1 in miliseconds
valid only when the ResetTimeIndex = RESET_TOGGLE_VCC_INDEX
[ CFG_APPLRESETVCCTIME 29 ]
ApplResetVccTime value 50 to 5000 step 1 in miliseconds
valid only when the ApplicationStartEn = APPLICATION_TOGGLE_VCC
[ CFG_POP_UP_EN 30 ]
PopUpEnable - enable or disable to display pop-up message in run time
0 - warning message popup disable
1 - enable all
2 - disable all
[ CFG_BSL_ENH_ENABLE 32 ] - BSL mode (valid for BSL version 2.0 and higher)
(See FlashPro430 Manual - chapter 9)
0 - disable
1 - enable
[ CFG_BSL_ENH_INDEX 33 ]
(See FlashPro430 Manual - chapter 9)
BSL_ENH_DISABLE 0 Disable access via BSL
BSL_ENH_NONE 1 Do not erase flash if the BSL password is invalid
(allows to make a next try)
BSL_ENH_ERASE 2 Erase whole flash if the BSL password is invalid
(one try only)
[ CFG_RETAIN_CAL_DATA_INDEX 34 ]
59