(See FlashPro430 Manual - chapter 6)
0 - Disable retain the DCO Calibration Data for the F2xx family.
1 - Enable retain the DCO Calibration Data for the F2xx family. Data are
saved in the INFO flash memory at location 0x10F8 to 0x10FF
[ CFG_RETAIN_DEF_DATA_INDEX 35 ]
(See FlashPro430 Manual - chapter 6)
0 - Disable retain the user defined data in flash.
1 - Enable retain the user defined data in flash. Data specified in the
user defined location (see indexes below) will be restored after
erase and program.
[ CFG_RETAIN_START_ADDR_INDEX 36 ]
start address - start address for the user defined retain data
(protected data) in flash.
Size of protected data can not exceed 256 bytes.
[ CFG_RETAIN_STOP_ADDR_INDEX 37 ]
stop address - stop address for the user defined retain data
(protected data) in flash.
Size of protected data can not exceed 256 bytes.
[ CFG_APPLPRGRUNTIME 38]
data 0 - unlimited time
1 to 120 seconds - (limited time)
[ CFG_RELEASEJTAGSTATE 39]
DEFAULT_JTAG_3ST 0
DEFAULT_JTAG_HI 1
DEFAULT_JTAG_LO 2
[ CFG_RUNTIMETDIGENEN 40]
0-disable, 1-enable
[ CFG_RUNTIMETDIGENDIV 41]
data 1 to 255
[ CFG_RUNTIMETDIGENPRESCALER 42 ]
RUNTIMETDIPRESCALER_6MHZ 0
RUNTIMETDIPRESCALER_2MHZ 1
[ CFG_DCO1_CAL_ENABLE 43 ]
[ CFG_DCO2_CAL_ENABLE 44 ]
[ CFG_DCO3_CAL_ENABLE 45 ]
[ CFG_DCO4_CAL_ENABLE 46 ]
[ CFG_DCO5_CAL_ENABLE 47 ]
[ CFG_DCO6_CAL_ENABLE 48 ]
[ CFG_DCO7_CAL_ENABLE 49 ]
[ CFG_DCO8_CAL_ENABLE 50 ]
60
To Next Page
Loading...