Elprotronic MSP430 - Page 61

0-disable, 1-enable
[ CFG_DCO1_CAL_FREQ_INDEX 51 ]
[ CFG_DCO2_CAL_FREQ_INDEX 52 ]
[ CFG_DCO3_CAL_FREQ_INDEX 53 ]
[ CFG_DCO4_CAL_FREQ_INDEX 54 ]
[ CFG_DCO5_CAL_FREQ_INDEX 55 ]
[ CFG_DCO6_CAL_FREQ_INDEX 56 ]
[ CFG_DCO7_CAL_FREQ_INDEX 57 ]
[ CFG_DCO8_CAL_FREQ_INDEX 58 ]
range from 100 to 16000 (100kHz to 16 MHz)
see the MSP430 data sheet for acceptable freq range.
[ CFG_DCO_DEFINED_ADDR_EN 59 ]
0-disable, 1-enable
[ CFG_DCO_DEFINED_ADDRESS 60 ]
DCO block base address
[ CFG_RUNTIMEBSLTXGENEN 61 ]
0-disable, 1-enable
[ CFG_MASSERASE_AND_INFOA_EN 63 ]
Valid only for MSP430F2xx
0-disable - INFO-A erase disabled when the mass memory erase is enabled.
1-enable - INFO-A erase enabled when the mass memory erase is enabled.
[ CFG_DCO_CONST_2XX_VERIFY_EN 64 ]
Valid only for MSP430F2xx
0-disable, 1-enable
[ CFG_DCOCAL_2XX_EN 65 ]
Valid only for MSP430F2xx
0-disable, 1-enable -> make a DCO calibration if DCO constants are
invalid.
[ CFG_FIRST_BSL_PASSW_INDEX 66 ]
0 - FIRST_BSL_PASSW_DEFAULT
1 - FIRST_BSL_PASSW_FROM_PASSW_FILE
2 - FIRST_BSL_PASSW_FROM_CODE_FILE
3 - FIRST_BSL_PASSW_EMPTY
[ CFG_CS_TYPE_INDEX 69 ]
0 - " n o n e "
1 - "Arithmetic sum ( 8b / 16b )"
2 - "Arithmetic sum ( 8b / 32b )"
3 - "Arithmetic sum (16b / 16b )"
4 - "Arithmetic sum (16b / 32b )"
5 - "CRC16 (Poly = 0x11021) ( 8b / 16b )"
61