21
• Click on 'submit' after this.
The camera restarts automatically when you click 'submit'. This takes approximately 30
seconds.
• Close your browser and camera tool after the computer has restarted.
• Remove the network cable from the camera.
• Open the IP camera tool and click on your camera's address. You can now operate your
camera wirelessly.
• If your camera is not in the camera tool window, right click on the tool window, then
press the "refresh camera list" option.
4.6. Camera installation
Please note! Make sure that the camera functions properly in the chosen location
before starting installation.
You can choose to place the camera on a at surface, or to attach the camera to the
location of your choice with screws.
To mount the camera using screws, perform the following steps:
• Screw in the base of the camera with the aid of the 4 included screws
5
.
Please note! If the surface is too hard for the screws (stone/concrete), you will need to
drill holes and use the screw plugs which are included.
• Screw the camera back onto the base.
6
4.7. Adjusting the camera angle
• Unscrew the knob on the side of the base
7
.
• Then adjust the camera angle and tighten the knob again
8
.
5. Managing your camera using your
smartphone
Make sure your camera(s) is/are connected to your smartphone via the ELRO INSTALL App
(see section 4.1 and 4.2).
5.1. You can view your camera image on your Android
smartphone
• On the initial screen of the App press the camera you want to manage.
N
The camera
picture appears on your smartphone.
O
• Swipe your nger across the screen to zoom in and out and to move the camera image.
Attention! If you do not have a picture it is possible that your wireless connection is
not fast enough. In that case change the resolution of your camera image (see section
5.1.1)
The camera screen provides a number of options:
• Press the "Snapshot" button
O1
to make a snapshot of your camera image.
• Press the "mute/listen/speak" button
O2
to adjust your sound settings.
To Next Page
Loading...
