Elsema 240S1 Series - Setup Instructions

8 Controller Card for 240VAC Motors
A B C
D
87
E
Close
8
Push Button
Open Only
Close Only
Stop
Ped Access
Photo Beam
Normally Open
(NO)
Normally Closed
User can change
Common Common
+ -
24V DC out
150mA max
Status LED's
Test buttons
Open
Close
Slow Speed or
Force adjustment
240S1
Electrical Wiring
Alwaysswitchoffpowerbeforedoinganywiring.
Makesurethatallthewiringiscompletedandthatthemotorisconnectedtothecontrol
card.Recommended wire strip length should be 10mm for all connections to
the plug in terminal blocks.
Inputs and Outputs Diagram
Thediagrambelowshowstheinputsandoutputsavailable,theirfactorydefaultsettings,statusLED’s
andthetestbuttonforeachinput.
Setup Instructions
DANGER
Mains
voltage