What to do if there is no sound from the rear speakers of my Eltax AVR-320?
If you're not getting any sound from the rear speakers on your Eltax Receiver, make sure the SURROUND ON/OFF button is set to the desired surround sound mode. Also, ensure you are using a surround or stereo source. Finally, check all rear speaker cables to ensure they are properly connected.
Why does the sound cut off on my Eltax AVR-320?
If the sound cuts off or there's no sound at all from your Eltax Receiver even when it's powered on, it might be because the speaker impedance is too low for the unit. Turn off the power, then turn it back on, and either reduce the volume or switch to the correct 4 ohm speakers.
What to do if the sound from my Eltax AVR-320 is distorted?
If you are experiencing a distorted sound or low volume with your Eltax Receiver, it could be due to interference with the broadcast signals. If you're using an indoor antenna, try switching to an outdoor antenna.
Why is my Eltax Receiver remote control not working?
If the remote control for your Eltax Receiver isn't working, the batteries might be dead. Try replacing them with new ones. Also, make sure you're operating the remote control within its effective range.
How to fix sound only coming from one channel on my Eltax AVR-320 Receiver?
To resolve the issue of sound only coming from one channel on your Eltax Receiver, ensure that all input cables are securely connected. Also, check the BALANCE control to make sure it is properly adjusted.
Why is there excessive distortion in stereo mode on my Eltax AVR-320?
If you're experiencing excessive distortion in Stereo mode on your Eltax Receiver, it could be due to a weak signal. Try using an antenna with more elements to improve signal strength.
How to correct reversed speakers on my Eltax AVR-320?
If you notice that the left and right speakers are reversed when listening to music in stereo on your Eltax Receiver, the speaker connections are likely incorrect. Check the speaker connections and reconnect them to the correct output on the rear panel of the unit.
Why is the bass response low on my Eltax AVR-320?
If you're experiencing low bass response with your Eltax Receiver, the speaker polarity (+/-) might be reversed. Check all speakers to ensure they have the correct polarity.
Why is there a hissing noise in stereo on my Eltax AVR-320?
If you are hearing a hissing noise when listening to broadcasts in stereo on your Eltax Receiver, but not in Mono, it's likely due to the modulation method used for FM stereo broadcasts. Try reducing the treble sound by adjusting the treble controls.
How to reduce white noise on my Eltax AVR-320?
If you're experiencing excessive white noise in both stereo and monaural broadcasts on your Eltax Receiver, it could be due to the antenna's location or direction, or the transmitter station being too far away. Try setting the FM mode to monaural by pressing the STEREO/MONO button. Note that the broadcast will then be heard in Mono.
Covers grounding, overloading, power sources, antenna grounding, and cable protection.
Advice on installation location, unit handling, and basic operation.
Example layout and recommendations for surround sound speaker placement.
Diagram and explanation of rear panel speaker output terminals.
Detailed explanation of each button and indicator on the front panel.
Identification and purpose of all input/output terminals on the rear panel.
Diagram identifying all buttons on the remote control.
Steps to turn on the unit, select sources, and adjust volume.
How to configure speakers and select bass modes based on size.
Using test tone to balance speaker volume levels for surround sound.
Explains the benefits and features of Dolby Digital 5.1 surround sound.
Explains the features and benefits of DTS Digital Surround for 5.1 channel audio.
Common issues with audio output, hum, and tuner reception.
Troubleshooting sound problems and remote control malfunctions.
Details on rated power output, frequency response, sensitivity, and impedance.
To Next Page
General
