Why is there no sound from the center speaker on my Eltax Receiver?
If you are not getting any sound from the center speaker of your Eltax Receiver, the SURROUND mode may not be set correctly. Set the SURROUND mode to DOLBY DIGITAL, DTS, or DOLBY PRO LOGIC.
How to eliminate hum from my Eltax AVR-320 Receiver?
If you're hearing a low hum or buzzing sound from your Eltax Receiver, it could be due to interference from nearby electrical devices. Place the receiver as far as possible from electric devices that emit electrical interference, such as fluorescent lights or power cables.
Covers grounding, overloading, power sources, antenna grounding, and cable protection.
Advice on installation location, unit handling, and basic operation.
Example layout and recommendations for surround sound speaker placement.
Diagram and explanation of rear panel speaker output terminals.
Detailed explanation of each button and indicator on the front panel.
Identification and purpose of all input/output terminals on the rear panel.
Diagram identifying all buttons on the remote control.
Steps to turn on the unit, select sources, and adjust volume.
How to configure speakers and select bass modes based on size.
Using test tone to balance speaker volume levels for surround sound.
Explains the benefits and features of Dolby Digital 5.1 surround sound.
Explains the features and benefits of DTS Digital Surround for 5.1 channel audio.
Common issues with audio output, hum, and tuner reception.
Troubleshooting sound problems and remote control malfunctions.
Details on rated power output, frequency response, sensitivity, and impedance.
To Next Page
General
