What to do if the remote control of my Eltax AVR-900 is not working?
If the remote control isn't working, the batteries may be exhausted, so try replacing them with new ones. Also, make sure you are operating the remote control within its effective range of the Eltax Receiver.
What to do if sound cuts off when listening to music on my Eltax AVR-900 Receiver?
If the sound cuts off or there's no sound even when the power is on, it might be because the speaker impedance is less than what's prescribed for this unit. Turn off the power, then turn it on again, reduce the volume, or change to the correct 8 ohm speakers.
Why is sound only heard from one channel on my Eltax AVR-900?
If sound is only coming from one channel, check if one of the input cords is disconnected or if the BALANCE control is set to one side. Connect the input leads and adjust the BALANCE control accordingly.
How to fix left and right speakers reversed on my Eltax Receiver?
If the left and right speakers are reversed when listening to music in stereo, it's likely that the speakers are connected incorrectly. Check the connections and reconnect if needed.
Why is there no sound from the rear speakers of my Eltax AVR-900?
If there's no sound from the rear speakers, it could be due to several reasons: * The SURROUND ON/OFF button might be set to OFF, so set the button to the desired surround mode position. * The source being played is not recorded or broadcast in surround sound or stereo, so use a surround or stereo source. * The cable may not be connected securely, so check all rear speaker wires for a good connection.
Why is there no sound from the center speaker of my Eltax AVR-900 Receiver?
If there is no sound from the center speaker, the SURROUND mode button is not set to DOLBY DIGITAL, DTS or DOLBY PRO LOGIC II. Set the button to DOLBY DIGITAL, DTS or DOLBY PRO LOGIC II.
What to do if the sound is distorted on my Eltax AVR-900 Receiver?
If the sound is distorted and/or the volume level becomes low, it could be due to poor broadcast signals or poor antenna placement. If you're using an indoor antenna, try changing to an outdoor antenna.
How to fix low bass response on my Eltax AVR-900?
If you're experiencing low bass response, the speaker polarity (+/-) might be reversed. Check all speakers for correct polarity.
How to eliminate hum or buzz sound from my Eltax AVR-900?
If you're hearing a low hum or buzz sound, it might be because power cords or lighting are placed too close to the product. Place the Eltax Receiver as far as possible from lighting or power leads.
Why is there excessive noise in stereo and monaural broadcasts on my Eltax AVR-900?
If there's excessive noise in both stereo and monaural broadcasts, it could be due to a poor location and/or direction of the antenna, or the transmitted station is too far away. Set the FM mode to monaural by pressing the STEREO/MONO button. Note that the broadcast will then be heard as monaural sound.
Covers instructions, warnings, cleaning, grounding, overloading, power, accessories, and attachments for safe operation.
Lists specific situations where the unit should be unplugged and referred to qualified service personnel.
Prohibits self-servicing, specifies replacement parts, and requires safety checks after repair.
Essential instructions and precautions to read before operating the unit for the first time.
Important cautions and guidelines to follow before connecting any equipment to the receiver.
Detailed explanation of each button and control on the receiver's front panel with their functions.
Explanation of each button on the remote control and its corresponding function for operating the receiver.
Detailed explanation of each input and output port on the rear panel and their connection purposes.
Instructions for powering on, standby mode, and selecting audio/video sources using the input selector.
Instructions for selecting and playing video sources using the INPUT SELECTOR and connecting to the TV.
Using the test tone function to adjust the relative volume levels between speakers.
Common problems related to sound, hum, buzz, and tuner reception with suggested solutions.
Troubleshooting no sound from rear/center speakers and unresponsive remote control.
To Next Page
General
