User Manual THEIA HE-t String Inverters 357115.013, Issue 1.0, 2011 April 73
8.3. Replace Devices
It is possible to add new inverters, or replace existing inverters, in a PV system.
Slave
• If the replaced inverter is a slave, the master inverter will automatically identify the replaced
device, transfer critical settings, and put it into operation.
• The device number is automatically maintained.
Master
• If the replaced inverter is the master and master functionality is desired, an existing inverter
must be set up as master. This is done in Setup>Network Setup>Set as Master unit. Select
YES, and an automatic logon-sequence is performed.
8.4. Return and Disposal
When replacing an inverter, it can either be returned to your distributor, to Eltek Valere direct,
or disposed of according to local and national regulations. Eltek Valere is committed to its
policy of environmental responsibility, and therefore appeals to end users who are disposing
of inverters to follow local environmental legislation and to seek safe, responsible means of
disposal.
8.4.1. Return
For return to Eltek Valere the inverter should always be in its original packaging or equivalent
packaging.
In case of return of the product as a result of inverter failure, a fault report must be submitted
to obtain a Return Material Authorization (RMA) number.
The fault report template can be found at: http://www.eltekvalere.com/support
Prior to Return:
• Loosen the locking screws attached to the fixing clip on the mounting bracket.
• Pull the inverter up and out of the bracket.
• Pack the inverter securely in the packaging.
• Add a fault report if relevant.
• Return to the given address in the respective country/continent
8.4.2. Disposal
In case of end of service life, the inverter can be returned to your distributor, to Eltek Valere
direct, or disposed of in the respective country. The shipping to the distributor or Eltek Valere
is paid by the sender.
Recycling and disposal of the THEIA HE-t inverter must be done according to the rules and
regulations applicable in the country of disposal. All the inverter packaging material is
recyclable.
photovoltaikforum.com
To Next Page
Loading...
Need help?
General