3
First use of the camera
Immediately after unpacking the camera, its internal battery can be fully
discharged. Please connect to a charging adaptor for at least 15 minutes. If
camera does not turn on automatically or pressing the ON button does not
help, please press the RESET button.
Sound settings
To completely mute all sounds, please press and hold the down arrow
button. To unmute the sound please press and hold the up arrow button.
How to mount the holder
Please place the sucker on the clean and ungreased glass. Push the sucker
against the glass and rotate the segment with USB connector 90 degress
clockwise. In winter please check that glass and sucker are not frozen. It can
lead to wrong connection and falling off. If you prefer to mount your camera
to a vertical glass (e.g. in a bus or truck), please ask your seller for a special
„vertical glass“ mounting kit.
How to plug the camera to the holder
Plug the camera into the grooves of the holder until you reach connection
with the magnetic segment. Never use a strong power. To unplug the camera
please hold the black metal part of on the top of the camera and pull the
camera out.
Usage in traffic
While using the camera always respect the laws. Plug the camera into the
holder just after turning on the engine. Camera turns on automatically and
the recording starts. Before leaving the car, unplug the camera from holder.
The recording will be saved automatically and camera turns off.
To Next Page
Loading...