58 Installation - ENGLISH
1. Lift up the hose to the tap.
2. Screw the connector onto the threads of the tap.
Connect the safety supply hose to a tap
Use the safety supply hose to ensure that the flow of water will stop if the hose is damaged. The hose is double-walled
and the air space between the inner and the outer corrugated hose fills up with water if the hose is damaged.
CAUTION!
• If the water pipes are new or have not been used for an extended period of time, let the water run to
make sure that the water is clear. This precaution is necessary to avoid the risk of the water inlet
becoming blocked and damaging the dishwasher.
• If your sink has a spray jet fed by a hose that is connected to the same water line as the dishwasher the
hose could burst. If your sink has one, it is recommended that the hose be disconnected and the hole
plugged.
To Next Page
Loading...
Need help?
General
