Your Classic Sensor is equipped with a unique feature which enables
you to reduce the brightness of the Classic Sensor ‘flash’ and to
reduce the length of flashing when your equipment is no longer
being used.
Your device is shipped with the brightness level set to maximum,
however you may wish to enable BedroomMode™ to reduce the
brightness of the Classic Sensor light in a bedroom. BedroomMode™
is not recommended for living rooms or brightly lit areas.
To Set using the Classic Sensor:
Make sure that at least your TV is switched on before starting.
1. Press and hold the SET button on the Classic Sensor for 3 seconds
then release. The LED light on the front of the sensor will flash,
starting from a faint flash slowly progressing to a bright flash.
2. When you are happy with the level of brightness, press the SET
button on the Classic Sensor again.
3. You can change the brightness of the Classic Sensor at any time by
following the above steps.
NOTE: Once BedroomMode™ is selected, the LED will flash for
about 10 seconds when you turn off your television before the
power is removed from the Power Saving outlets.
If you prefer the LED to flash for one minute, press the MUSIC
button instead of the SET button at step 2.
BedroomMode™ settings
12
To Next Page
Loading...