EMC-PARTNER IMU4000 User Manual

E-IMU4000-E-Manual 1/104
User Manual IMU4000
This User Manual is valid for all versions of IMU4000
Title: EMC Test System IMU4000
Date: 10.07.2012
Product Manager: M. Sacchi
Calibration Manager: R. Henz
Technical Manager: M. Lutz
Revised: 20.06.2014
EMC TESTER
IMU4000 and Versions

EMC-PARTNER IMU4000 Specifications

General

Brand	EMC-PARTNER
Model	IMU4000
Category	Test Equipment
Language	English

Summary

DESCRIPTION

1.2 Overview of the IMU4000 test system

1.3 Technical data of the IMU4000

Lists technical specifications for ESD, EFT, SURGE, interruptions, variations, and synchronization.

SAFETY

2.1 Safety standard

Outlines the safety standards and conformity declarations for the IMU4000.

2.3 Precautionary measure during use

Provides essential safety rules and precautions for operating the IMU4000.

2.4 Electromagnetic Compatibility

CONTROL PANEL

4.1 Front panel of the IMU4000

Details the front panel elements including control and operation panels.

4.2 Rear Panel of the IMU4000

Details rear panel connections, warnings, power supply, and external control interfaces.

PREPARATION FOR OPERATION

5.3 Checks before operation

Guides on manual references, operator qualifications, and pre-operation checks.

5.4 EUT Power, supply of the EUT with dc

Explains how to supply DC power to the EUT and potential configurations.

5.5 Hints for the test set up according to IEC standards

Provides practical guidance for setting up tests according to IEC standards.

5.6 Practical testing sequence

TESTING WITH THE IMU4000

6.1 Operation of the tester via touch screen monitor

Explains basic operation of the tester using the touch screen monitor.

6.2 The general menu

Details navigation through the general menu, including Setups, Linker, Protocols, and Settings.

6.3 EMC test operation „RUN Mode“

Describes modes like RUN mode, Standby mode, and the use of Trigger and Emergency Stop.

MAINTENANCE AND SERVICING

7.1 Maintenance

Covers routine maintenance tasks like cleaning filters and general cleaning of the unit.

7.3 Verification versus Calibration

7.4 Verification of the IMU4000 by the user

7.5 Calibration of the IMU4000 by EMC PARTNER AG

WHAT MUST BE DONE FOLLOWING FAILED OPERATION

8.1 Service; Repairs

Provides information on service, repairs, spare parts, and contact details.

8.3 Check before you contact the service of EMCP

Accessories

11.1 TRA accessories to IMU4000 Versions

11.2 Use of TRANSIENT accessories

Remote Ports

12.1 General

12.2 Software "TEMA3000" for IMU4000

Introduces the TEMA3000 software for controlling the IMU4000 remotely.