Status : Ok
Slot Number : 4
Enclosure Device ID : 9
Status : Ok
Slot Number : 5
Enclosure Device ID : 9
Status : Ok
In the output above, the hard drive whose status is not Ok is the one that must be
replaced. Take note of the Enclosure Device ID and Slot Number of the hard drive for
use in the remaining tasks.
If all hard drives are Ok, confirm the drive bay number for the drive to be replaced.
Contact EMC Customer Support for clarification.
Replacing a hard drive
After identifying the node and the defective hard drive, perform the following steps to
replace the hard drive.
Removing the hard drive
Procedure
1. From the front of the cabinet, press both tabs on the front of the bezel.
Figure 7 Bezel Removal
2. Pull the bezel away straight from the rack.
3. Using the physical disk ID provided by EMC Technical Support and verified above,
locate the defective hard drive.
Replacing a Hard Drive
Replacing a hard drive 19
To Next Page
Loading...
Need help?
General
