EasyManua.ls Logo

EMC VNX5500 - Page 24

EMC VNX5500
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24 VNX5500 Hardware Information Guide
System component description
Table 9 describes the SPS LEDs.
SPS RJ-12 connector
Figure 13 on page 25 shows the SPS (RJ-12 or modular jack) management port (labeled
with two symbols; one depicting a telephone handset with a line through it and the other
depicting a rectangle with a line through it). Both symbols mean that you cannot connect
telephone type circuits to this connector (see the following WARNING). This port connects
the SPS (A and B) ports to the SP (A and B) ports, respectively.

The SPS (RJ-12) port is a LAN port not a WAN port. LAN ports contain safety extra-low
voltage (SELV) circuits, and WAN ports contain telephone-network voltage (TNV) circuits.
An RJ-45 (or TNV-type) looks the same as the RJ-12 except for two very important
differences. An RJ-45 is an 8-wire modular jack. The RJ-12 is a six-wire modular jack. The
RJ-45 plugs and jacks are wider than their RJ-12 counterparts - 7/16" vs 3/8". An RJ-45
plug won't fit into an R-J12 jack. But an RJ-12 plug will fit into an RJ-45 jack. Use caution
when connecting cables. To avoid electric shock, do not attempt to connect TNV circuits
to SELV circuits.
Table 9 SPS LEDs
Led Color State Description
SPS power Green On SPS ready and operating normally; battery fully
charged
Blinking On/battery charging
Off Off/disconnected
SPS battery Amber On AC line power is no longer available and the SPS is
supplying DC output power from the battery.
Note: When battery power comes on, and no other
online SPS is connected to the SP, the system writes
all cached data to disk, and the event log records
the event.
SPS no battery Amber On SPS battery is not fully charged and might not be
able to serve its cache flushing function. With the
battery in this state, and no other online SPS
connected to the SP, the system disables write
caching, and writes any modified pages to the disk
first. Replace the SPS as soon as possible.
SPS fault Amber On The SPS has an internal fault. The SPS might still be
able to run online, but write caching cannot occur.
Replace the SPS as soon as possible.

Other manuals for EMC VNX5500

Related product manuals