EMC VNX5500 - Page 27

System component description
VNX5500 Hardware Information Guide 27
• RS-232/EIA status LEDs
• SP latch handles (bottom, left and right)
Figure 16 shows the location of these components.
Figure 16 Example of SP components (rear view)
1 AC (power in) recessed connector (plug) 8 Two RJ-45 (management and service
laptop) connectors (labeled with a
network management symbol and a
wrench symbol, respectively)
2 Power supply fault LED (amber) 9 SP unsafe to remove LED
3 Power supply power on LED (green) 10 SP fault LED (amber)
4 Power supply latch handle 11 SP power on LED (green)
5 Two I/O module slots showing a four-port
8-Gb/s Fibre Channel (FC) I/O module and
a four-port 1-Gb/s iSCSI I/O module
12 Two RS-232/EIA (micro DB-9) connectors
(labeled with a battery symbol and a
wrench symbol, respectively)
6 Two SP latch handles (bottom left and
right)
13 Four 8-Gb/s Fibre Channel ports (labeled
8Gb fibre 2, 3, 4, and 5)
7 Two 6-Gb/s SAS ports
X4
2
3
4
5
6Gb
SAS
8Gb
bre
1
0 X4
6Gb SAS
2
1 4
789
10
6
13
1112
3
0123
PART NUMBER
REV A09 A
0
123
PART NUMBER
REV A09 A
VNX-000568
5