EMC VNX5500 - Page 57

I/O modules
VNX5500 Hardware Information Guide 57
Two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module
The two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module (labeled 10 GbE Base-T on the
latch handle) comes with two 10-Gb/s Base-T copper ports, one power/fault LED, and a
link and activity LED for each port (Figure 50). The Base-T ports on this I/O module can
interface at speeds of 10 Gb/s for iSCSI networks. The two-port 10-Gb/s Base-T I/O
module uses EIA Category 6 or 6a Unshielded Twisted Pair (UTP) or EIA Category 7 fully
Shielded Twisted Pair (STP) copper cabling (for more information about these types of
cables, see Table 16, “Ethernet cabling guidelines,” on page 34 or Table 21, “Ethernet
cabling guidelines,” on page 40).
Figure 50 Two-port 10-Gb/s RJ-45 Base-T I/O module
1 Push button latch handle 4 Link LED (right)
2 Power/fault LED 5 Activity LED (left)
3 RJ-45 Base-T port (2)
10
1
2
3
4
5
VNXe-000751