14 VNX5700 Hardware Information Guide
VNX5700 Block and File product description
• One CPU module consisting of one Intel Xeon 4-core 2.40-GHz processor
• Six DDR3 synchronous dynamic RAM (SDRAM) slots supporting 2, 4, or 8-GB
SDRAM for up to 12 GB per CPU module
• Five PCI Gen 2 x4 I/O module slots supporting a combination of the following four
UltraFlex I/O modules:
– Four-port 8-Gb/s optical (running at 2, 4, or 8 Gb/s); in slot 0
– Two-port 10-Gb/s optical or active Twinax
7
–Four-port 1-Gb/s copper
– Two-port 1-Gb/s copper plus two-port 1-Gb/s optical
• Two management modules per Data Mover enclosure (or, one per Data Mover)
• Two power supply/cooling (fan) modules per CPU module
◆ One to two Control Stations. Each Control Station consists of the following features:
• Intel 2.0 GHz single core Celeron processor
• 2 GB of RAM
• One 250-GB SATA hard drive
• Two rear-mounted USB ports and one front-mounted USB port
• Four RJ-45 10BASE-T/100BASE-TX/1000BASE-T network interface connectors
(located on the rear panel)
• Two integrated serial ports, one for laptop/console redirection and one for the
CallHome modem
• One DVD-ROM drive
• Two Ethernet (RJ-45) extension cables
◆ Expansion of up to thirty-three 3U, 15 (3.5-inch) disk drive DAEs (a maximum of 495
drives) or up to twenty 2U, 25 (2.5-inch) disk drive DAEs (a maximum of 500 drives)
◆ Any required cables including LAN cables, modem cables, and serial DB-9 cable.
◆ Mounting rails with hardware
◆ Front bezel with VNX5700 badge
VNX5700 platform using a combination of 4U and 3U DAEs
Contained in a 9 to 10U architecture, the Block and File (Unified) VNX5700 platform
weighs approximately 280.91 lb (127.42 kg)
6
. With the dual 2U SPS having the deepest
dimension within the cabinet, the VNX5700 measures 15.75 to 17.5 inches high (9 to
10U) x 18.92 inches wide x 28 inches deep (40 to 44.45 cm 48.05 cm x 71.12 cm).
Between the front and rear enclosure, a midplane distributes power and signals to all the
enclosure components. The CPU modules and the power supply/cooling (fan) modules
plug directly into the midplane connections.
6. A fully loaded Block and File (Unified) VNX5700 platform includes two Control Stations, one SPE,
one dual 2U SPS, and two Data Mover enclosures (with four Data Movers).
To Next Page
Loading...
