30 VNX5700 Hardware Information Guide
System component description
2U SPS rear view
When using the Block and File (Unified) VNX5700 platform with the 4U, 60 disk drive DAE
as the Vault drive in 40U Dense rack, the dual 2U, 2.2-kilowatt standby power supply
(SPS) is used to maintain power to the Block and File (Unified) VNX5700 platform SP
during power loss. Just like the 1U SPS, the 2U SPS performs the same functionality.
Looking from left to right, Figure 18 shows an example of the rear view of a dual 2U SPS.
Figure 18 Example of 2U SPS B and A viewing from left to right (rear view)
2U SPS LEDs
Figure 19 shows the LEDs located on each 2U SPS (A and B)
Figure 19 2U SPS LEDs
1 SPS B AC power in (recessed plug) 7 SPS A to SP A management (RJ-12)
connector
2 SPS B power out socket to LCC B on the 1st
DAE (ID 2)
8 SPS A power on/off toggle switch
3 SPS B power out socket to the SP B power
supply on the SPE
9 Four SPS A status LEDs (green and amber)
4 SPS A AC power in (recessed plug) 10 SPS B to SP B management (RJ-12)
connector
5 SPS A power out socket to the SP A power
supply on the SPE
11 SPS B power on/off toggle switch
6 SPS A power out socket to LCC A on the 1st
DAE (ID 2)
12 Four SPS B status LEDs (green and amber)
1
32
SPS B
SPS A
VNX-000624
4 65
8 71011 9
12
SPS power
SPS battery
SPS no battery
SPS fault
VNX-000625
To Next Page
Loading...
