System component description
VNX5700 Hardware Information Guide 41
◆ One (DB-9 plug) serial console (RS-232/EIA-232) connector
◆ Two USB 2.0 connectors—not used
◆ POST diagnostic LEDs
Figure 31 shows the orientation of these components.
Figure 31 VNX5700 platform Control Station (rear view)
Control Station Input/output ports and connectors
The Block and File (Unified) VNX5700 platform Control Station supports the following I/O
ports on the rear of the Control Station:
◆ Four Ethernet (RJ-45) ports
◆ One serial modem (DB-9) plug connector
◆ One serial console (DB-9) plug connector
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution
when connecting cables.
1 AC power in connector 7 DB-9 serial console plug connector
2 PS/2 connector (mouse)—not used 8 Two USB 2.0 connectors—not used
3 DB-9 serial modem plug connector 9 RJ-45 Ethernet port (labeled A)
4 RJ-45 Ethernet port (labeled CS
1
)
1. The CS port uses an IPMI (Intelligent Platform Management Interface) cable to connect to a standby
Control Station).
10 POST diagnostic LEDs
2
2. These LEDs might light during power on self test (POST); they are not important for the administration or
maintenance of the Control Station.
5 RJ-45 Ethernet port (labeled B) 11 DB-15 Video (VGA) socket connector—not
used
6 RJ-45 Ethernet port (labeled MGMT) 12 PS/2 connector (keyboard)—not used
MGMT
B
A
CS
2 3 4 5 6 7
8910
11
12
1
CNS-001741
To Next Page
Loading...
