EMC VNX5700 - Page 41

System component description
VNX5700 Hardware Information Guide 43
Control Station Ethernet (RJ-45) port LEDs
The Control Station (RJ-45) include LEDs—a green LED to the left of the connector and a
bi-color (green/amber) LED to the right of the connector—that indicate the link/activity
and speed of the Control Station (RJ-45) ports, respectively (Figure 33).
Figure 33 Control Station Ethernet (RJ-45) port LEDs
Table 21 describes the link/activity and connection speed associated with the Control
Station (RJ-45) port LEDs.
Ethernet cable extensions for the Control Station B and MGMT ports
Each Block and File (Unified) VNX5700 platform Control Station comes with two modular
Ethernet cable extensions (or patch cords) for the RJ-45 ports (labeled on the CS as B and
MGMT, respectively). These cables allow you to extend the length of the Ethernet cables
from the CS 0, port B to Data Mover enclosure 0, management module B, port 1 and CS 0,
MGMT port to the public LAN.
If your Block and File (Unified) VNX5700 platform includes a second optional Control
Station (CS 1), another set of Ethernet cable extensions for the RJ-45 ports is provided.
These cables allow you to extend the length of the Ethernet cables from the CS 1, port B to
Data Mover enclosure 0, management module B, port 2 and CS 1, MGMT port to the public
LAN. Each cable includes a corresponding label clip to assist you during system cabling.
6 BI_DB- Bidirectional pair B, -
7 BI_DD+ Bidirectional pair D, +
8 BI_DD- Bidirectional pair D, -
Table 20 Control Station Ethernet (RJ-45) port and connector pinout
RJ-45 pin Signal Description
CNS-001748
1 2
Table 21 Control Station RJ-45 port LEDs
Led Color State Description
Left,
link/activity
(location 1)
Green On Network/link connection
Green Blinking Transmit/receive activity
— Off No network/link connection
Right, link
speed
(location 2)
Green On 100-Mb/s connection
Amber On 1000-Mb/s (or 1-Gb/s) connection
— Off 10-Mb/s connection (if left LED is on or blinking)