I/O modules
VNX5700 Hardware Information Guide 47
Note: The Lucent Connector (LC) type interface was developed by Lucent Technologies
(hence, Lucent Connector). It uses a push-pull mechanism. LC connectors are normally
held together in a multimode duplex configuration with a plastic clip. These cables are
usually colored orange with the duplex connectors encased in a gray plastic covering. To
determine the send or transmit (TX) and receive (RX) ferrules (connector ends), these
cables will show a letter and numeral (for example A1 and A2 for the TX and RX,
respectively) or a white and yellow rubber gasket (jacket) for the send or transmit (TX) and
receive (RX) ends.
Four-port 8-Gb/s FC I/O module LEDs
The four-port 8-Gb/s Fibre Channel (FC) I/O module has two different types of status LEDs.
Figure 38 shows the LEDs and Table 24 describes them.
Figure 38 Four-port 8-Gb/s FC I/O module LEDs
Link/Activity
LED
Power/fault
LED
Link/Activity
LED
Link/Activity
LED
Link/Activity
LED
CNS-001670
Table 24 Four-port 8-Gb/s FC I/O module LEDs
LED Color State Description
Power/Fault Green On I/O module is powered up.
Amber On I/O module has faulted.
— Off I/O module is powered down.
Link/Activity
(each port
has one
LED)
Green On 2- or 4-Gb link speed (suboptimal speed)
Blue On 8-Gb/s link speed (maximum speed)
Green or
Blue
Blinking Small form-factor pluggable (SFP+
1
) transceiver module
faulted, unsupported, or optical cable fault.
— Off No network connection
1. Refer to the
VNX5700 Parts Location Guide
for the part number label location for the SFP+ part number.
To Next Page
Loading...
