I/O modules
VNX5700 Hardware Information Guide 53
Two-port 10-Gb/s optical or active Twinax Fibre Channel over Ethernet (FCoE) I/O module
The two-port 10-Gb/s optical or active Twinax
17
FCoE I/O module comes with two FCoE
ports, one power/fault LED, and a link and activity LED for each port (Figure 45). The ports
on this I/O module can interface at speeds up to 10 Gb/s for Fibre Channel over Ethernet
networks. The two-port 10-Gb/s FCoE I/O module uses the SFP+ transceiver module. For
part number label location, see the
VNX5700 Parts Location Guide
.
Figure 45 Two-port 10-Gb/s FCoE I/O module
Table 27 Four-port 6-Gb/s SAS I/O module LEDs
LED Color State Description
Power/Fault Green On I/O module is powered up.
Amber On I/O module has faulted.
— Off I/O module is powered down.
Link/activity Blue On Network connection
Blinking Transmit/receive activity
— Off No activity
17. The FCoE I/O module can also use active twinaxial (Twinax) cables. Twinax is a type of cable
similar to coax, but with two inner conductors instead of one. These cables will be supplied in lieu
of the SFP+ transceiver module when so ordered.
1 Push button latch handle 4 SFP+ link LED (right)
2 Power/fault LED 5 SFP+ activity LED (left)
3 SFP+ (optical) port (two)
1
0
1
2
3
4
5
CNS-001756
To Next Page
Loading...
