◆
Select Start ➤ All Programs or Start ➤ Programs, then select EMC ➤ Unisphere Service
Manager ➤ Unisphere Service Manager
◆
From the System screen in Unisphere, click Launch USM in the right-hand taskbar
located under Service Tasks
2. Log in to your system.
3. From the System screen, select Diagnostics ➤ Verify Storage System to run the storage
system health check wizard.
Enabling call home
Note: Disable/Enable Responses (quiet mode) feature will automatically re-enable call home when the
timer you set to disable call home expires. Network connectivity between the storage system and the
call home monitoring station is required for the Software Assistant to automatically enable call home
and verify the call home rules.
Use Unisphere or naviseccli to enable call home for the storage system following this
maintenance activity.
Note: The procedure below details how to enable call home using Unisphere. As an alternative you
can use naviseccli on a Windows management client to enable call home:
naviseccli eventmonitor -monitor -enableresponse -user <username> -password
<password> -scope 0 -server <serverIPaddr>
1. Log in to the storage system or the Unisphere domain that contains the storage system.
2. From Unisphere, select System ➤ Monitoring and Alerts ➤ Notification and select the
Distributed Monitors tab.
3. Right click on the name of SP A in the list of distributed monitors for the storage system
on which you are enabling call home and select Disable/Enable Responses.
The Disable/Enable Responses dialog box appears.
4. De-select the Disable Responses check box and click OK.
5. Repeat these steps for SP B.
Important: You MUST enable responses on BOTH SP A and SP B to enable the storage system call
home.
Enabling call home 13
Finishing up
To Next Page
Loading...
Need help?
General
