To Next PageTo Next Page
Need help?Do you have a question about the Emec JAPH PRO Series and is the answer not in the manual?
General| Brand | Emec |
|---|---|
| Model | JAPH PRO Series |
| Category | Controller |
| Language | English |
Manual contains safety info indicated by icon. Keep controller protected from sun and water.
Emergency shutdown, local regulations, manufacturer liability, and accessibility for operation/servicing.
Safety for pumps, feeders, chemical handling, protective clothing, and reading datasheets.
Describes connections for Setpoint 1, Setpoint 2, Alarm, Standby, and Opto-coupled outputs.
Details connections for proximity sensors, RS485, Conductivity probe, PT100 probe, and mA output.
Details connections for Inductivity probe, SCL probe, ECL6 probe, PT100 probe, and mA output.
How to set a new administrator password with four numbers for accessing the main menu.
Lists main menu options like SETTINGS, FLOW, GENERAL OPTIONS, RESET INSTRUMENT, OUT MA, STAND-BY.
How to select K factor and automatic range for conductivity measurement on JA CD/CDIND series.
Explains PID controller basics: proportional, integral, derivative terms for process control.
Details setting Time Integrative, Time Derivative, and Mode for PID control in PRO models.
Steps for calibrating conductivity using a SLOPE value and buffer solution.
Procedure for calibrating temperature using a professional thermometer and PT100 probe.
Involves two points (Offset/Slope) using pH 4.00 and 7.00 buffer solutions for accurate pH measurement.
ORP calibration uses one point (P1), with options for FAST (1 buffer) or FULL (2 buffers) calibration.
