Emec JACL PRO Series - User Manual

1
OPERATING INSTRUCTIONS FOR
“JA SERIES” / “JA SERIES PRO” CONTROLLERS
This manual contains safety information that if ignored can
endanger life or result in serious injury. They are indicated
by this icon.
Keep the controller protected from sun and water.
Avoid water splashes.
Read Carefully !
ENGLISH Version
R19-07-19

Summary

General Safety Guidelines

Danger! Warnings

Safety advice for critical situations indicated by the 'Danger!' warning icon.

Caution! Precautions

Safety advice for operational and servicing precautions indicated by the 'Caution!' warning icon.

Mainboard Connections (JACD;JACD PRO)

Connections for Other JA SERIES Models

DC Version Model Connections

AC Version Model Connections

Quick Status Check Procedure

Password Management

Setting and Recovering Passwords

Instructions for setting, changing, and recovering the controller's password.

Main Menu Navigation

Settings Menu Options

Settings: Measure Configuration

Settings: Set-Point Configuration

Output 1, 2, and IS Configuration

ON;OFF Mode Operation

Proportional Mode Operation

PID Mode Operation (PRO Models)

PID Parameter Configuration

Setting Time Integrative, Time Derivative, and Mode for PID control.

PID Set-Point and Range

Defining the Set-Point and Range values for PID mode operation.

Calibration: JA CD Series

Conductivity Calibration Procedure

Steps to perform slope calibration for conductivity measurements.

Temperature Calibration Procedure

Calibration: JA PH Series

First Point Calibration (Offset)

Steps for the first point calibration using a 7.00pH buffer solution.

Second Point Calibration (Slope)

Steps for the second point calibration using a 4.00pH buffer solution.

Calibration: JA RH Series

ORP Probe Calibration Methods

Temperature Compensation

Compensation Options and Settings

Calibration: JA CL Series

Two-Point Chlorine Calibration

One-Point Chlorine Calibration

MODBUS Communication (PRO Models)

Flow Control Configuration

mA Output Configuration

mA Output Parameters

Standby Function Configuration

Standby Contact Settings

Emec JACL PRO Series Specifications

General

Manufacturer	Emec
Category	Controller
Operating Temperature	-10°C to +50°C
Protection	Overload, Short Circuit
Series	JACL PRO Series