To Next PageTo Next Page
Need help?Do you have a question about the Emec Centurio PRO and is the answer not in the manual?
Learn how to navigate the controller using its physical wheel and touch screen controls.
Details the terminal block connections for inputs and outputs on the mainboard.
Explains the wiring for main power supply and relay outputs on the mainboard.
Learn how to set and manage the password for accessing the controller's main menu.
Configure language, location, and date/time for correct operation and unit formatting.
Guide to calibrating various probes like conductivity and temperature sensors.
Procedure for calibrating the tracer probe with buffer solutions.
Steps for calibrating the pH probe using standard buffer solutions.
Instructions for calibrating temperature probes for accurate compensation.
Settings for configuring flow sensor inputs and their operational modes.
Configuration options for water meter inputs (WM1, WM2).
Enable and configure the ERMES remote management system.
Configure the controller for 3G/4G GSM mobile communication.
Set up a wired Ethernet connection for network communication.
Configure wireless internet communication using a WiFi module.
Configure phone numbers and email addresses for alert messages.
View historical data graphically for each channel.
Import/export data, logs, and firmware updates via USB.
Configure proportional control for inhibitor dosage based on corrosion rate.
Set up alarms for high corrosion values and manage alarm parameters.
Configure the flocculation procedure for colloidal particle removal.
Configure dechlorination pump and backwash cycles for pool filters.
Schedule shock chlorination activity for water disinfection.
Wiring details for various probes like CD, mA, pH, and Dissolved Oxygen modules.
Physical dimensions and environmental operating conditions for the controller.
General| Brand | Emec |
|---|---|
| Model | Centurio PRO |
| Category | Controller |
| Language | English |
