Emec Centurio PRO - Channels Setpoints Configuration

13
Channels setpoints menu.
For each channel (except for CONDUCTIVITY) a setpoint conguration (for DIGITAL and PROPORTIONAL outputs)
must be set to properly operate controller’s outputs. It’s also possibile to set the related temperature setpoint for each
channel (on/off mode only) and assign an output available.
Parameters to set are:
1) Working mode (digital or proportional)
2) Values
3) Output (if available)
4) Pulses per Minute
For each setpoint choose working mode.
Digital Setpoint conguration sample having two
values to work on.
Digital outputs available.
Proportional conguration sample having two values
and pulses per minute to work on.
Proportional outputs available.