To Next PageTo Next Page
Need help?Do you have a question about the Emec MTOWER PLUS Series and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Series | MTOWER PLUS |
| Operating Temperature | -10°C to +50°C |
| Weight | 0.5 kg |
| Protection | Overload, Short Circuit |
In emergencies, switch off the instrument immediately and disconnect the power supply.
Ensure instrument accessibility for operation and servicing; avoid obstructions.
Details on fuses, main power supply (90VAC to 265VAC), and earth connection.
Overview of input/output connections for probes, outputs, and alarm signals.
Procedure for setting and changing the passcode for accessing setup and probe menus.
Steps to access and set the instrument's date and time.
Guide to configuring units between EUROPE IS (Metric) and USA (Imperial) standards.
Procedure for calibrating the conductivity probe using P1 and P2 points.
Manual and automatic temperature compensation for conductivity measurements.
Enabling or disabling automatic temperature compensation for conductivity.
Procedure for the first calibration point of pH using buffer solution.
Procedure for the second calibration point of pH using buffer solution.
Adjusting temperature compensation for pH measurements.
Introduction to the ORP calibration procedure using a single calibration point.
Detailed steps for ORP calibration using a buffer solution or DPD1 method.
Procedure for calibrating the temperature probe using an external thermometer.
Configuration of 5 feeding modes for inhibitor: Feed & Bleed, % Bleed, % Time, Water Meter.
Configuring Setpoint, Dead Band, Time Limit, and Manual Bleed for bleed valve operation.
Enabling/disabling system alarms and configuring related outputs like conductivity, pH, ORP, and flow.
