Emec MTOWER PLUS Series - Manual Menu; Manual Output Operation

35
“Manual” menu.
This menu allows to manually operate all outputs. Move wheel on related output, press wheel two times to enable (ON)
and press wheel one more time to disable (OFF) selected output. Press one time again to re-enable (ON) output and
so on.
Outputs available are:
OUT D1 pH
This option manually operate output on 1-E-N blocks.
OUT Prop pH
This option manually operate output on 9 - 10 blocks (I/O connections)
OUT Prop mV
This option manually operate output on 7 - 8 blocks (I/O connections)
OUT Inhibitor
This option manually operate output on 11 - 12 blocks (I/O connections)
OUT Bleed
This option manually operate “Bleed” output on 7-8-9 blocks.
OUT INHIB
This option manually operate “inhibitor” output on 2-E-N blocks.
OUT PRE-BIO 1
This option manually operate “pre-biocide 1” output on 5-E-N blocks.
OUT PRE-BIO 2
This option manually operate “pre-biocide 2” output on 6-E-N blocks.
OUT D1 mV
This option manually operate output on 3-E-N blocks.
OUT BIO 2
This option manually operate “biocide 2” output on 4-E-N blocks.
OUT ALARM
This option manually operate “general alarm output” output on 10-11-12 blocks.
OUT mA 1
This option manually operate “mA output 1” output on 13-14 blocks.
OUT mA 2
This option manually operate “mA output 2” output on 13-15 blocks.
OUT mA 3
This option manually operate “mA output 3” output on 13-16 blocks.
OUT mA 4
This option manually operate “mA output 4” output on 13-17 blocks.
Move wheel on “EXIT” to return to “Menu setup” and automatically revert outputs to their original status.