Emec Centurio PRO - Filtration and Dechlorination; Chlorine Shock Chlorination

32
“Filtration” (dechlorination from pool’s lters)
Through this menu (Settings, Filtration) it is possible to congure the dechlorination pump from pool’s lters.
In order to correctly set this functionality, it is necessary to select the input level from those available that will activate the pump,
the type of contact (N.O normally open or N.C. normally closed), assign a name and select the relay output realted to the pump.
In the “Pressure Filter” menu it is possible to set the pressure differential for the dechlorination activity (eg: values above 30PSI /
2bar), the duration of the washing (Backwash in hours, minutes) the name and the relay on which pressure sensor is active (mA
module). Optionaly it is possible to set a weekly timer for scheduled dechlorination activity.
“Chlorine” (shock chlorination activity)
Through this menu (Settings, Chlorine) it is possible to set a daily / weekly timer to activate shock chlorination.. This
procedure allows you to disinfect the water effectively, destroying the polluting elements that cause turbid water, bad
smell or algae proliferation.
Parameters to set are: in the “Chlorination Schedule” submenu the days / hours when shock chlorination activity occurs
and in the “Chlorination Settings” submenu the waiting time after shock chlorination procedure (HOLD) before returning
to normal dosing activity, the relay on which the pump for chlorination activity (PUMP) is connected, the duration of the
pump activity forchlorination shock (PUMP TIME). In the “CHLORINE” menu it is also possible to set the display of the
combined chlorine (difference between total chlorine and free active chlorine, necessary for the detection of organic and
inorganic nitrogen-based pollutants).