Quick Installation Guide
00825-0100-4420, Rev DA
July 2009
1420 Wireless Gateway
9
To configure the 1420 for a Serial connection:
is available to assist in recording the necessary information.
1. Configure 1420 Serial Communication Settings
a. Access the 1420 Web Interface with Administrator access
b. Navigate to Setup>Modbus>Communication
c. Click Enable Modbus
d. Configure the 1420 Modbus Communication settings to match the Host Modbus
settings
NOTE:
Modbus communications will fail if they are not configured identically on the Host
and the 1420.
e. Click Submit and proceed with restart
2. When configuration is completed, disconnect the PC/laptop from the 1420 and return the
PC/laptop to its previous network settings.
00825-0100-4420_Rev_DA.fm Page 9 Friday, July 17, 2009 10:15 AM
To Next Page
Loading...
